Beskrivelse | Details
min. workpiece diameter:50 mm
workpiece length:500 mm
total power requirement:60 kW
horizontal stroke:200 mm
vertical stroke:200 mm
Description
Balance shafts 1.1 Description of the basic machine concept - Horizontal end machining center for simultaneous end machining on both sides of wave-shaped parts - Cutting, centering, drilling, cross-drilling, chamfering, slot milling, etc. - Workpiece lengths up to approx. 500mm Machine base body and slide - Machine stand in compact design - Two three-axis modules with x, y and z axes, drives via AC servo motors and ball screws, linear guides size 45 Hydraulic unit - Mounted on the back of the machine - This means very good accessibility Central lubrication - Guides - Ball spindles (bearings and nuts) Tool carrier system - Right side of the machine: 2 x 6-fold crown turret - Left side of the machine: permanently installed motor spindle Electrical control cabinet - Authorized by VDE 0113 and EN 60204 Part 1 - 400V / 50Hz Machine paneling / work area - Machine is fully loaded - see the details of the revolver, motorspin and span - Work area lighting Machine painting - Textured paint, silky gloss - Machine cover light gray RAL 7035 - Work area doors and cladding frames blue RAL 5002 Tool carrier system, right side of the machine - 6-fold crown revolver, made by Hellmerich - Tool holder HSK63 - Max. Torque. 110Nm - Power max. 20kW - Nmax=8,600 rpm - Tool change 0.75 sec. - Chip-to-chip time 1.5 seconds. Motor spindle, left side of the machine - Tool holder HSK63 - Max. Torque. 150Nm - Power max. 20kW - Nmax=5,000 rpm |
/uploadpic/tramaofinal_inserat/bilder/96284/bild1.jpg,/uploadpic/tramaofinal_inserat/bilder/96284/bild2.jpg,/uploadpic/tramaofinal_inserat/bilder/96284/bild3.jpg,/uploadpic/tramaofinal_inserat/bilder/96284/bild4.jpg,/uploadpic/tramaofinal_inserat/bilder/96284/bild5.jpg
